Language: EN
Start free

Give the bag its shape, then take the photo.

A bag has nothing inside to hold it up, so it photographs as whatever it happens to be doing: slumped, creased or tangled in its own strap. Most of the work is finished before the phone comes out. Once the bag stands, a short series of photos answers nearly everything a buyer asks, from the silhouette to the stamp on the inside tag.

The brown leather tote alone on a white studio background, front view
Source photo: On a door. Made with Herofab · Packshot studio

1. Stuff the bag until it stands

Empty the bag completely, pockets included, and shake out crumbs and old receipts. Then fill it with tissue paper, bubble wrap or a small cushion, pressed into the corners of the base first and built up until the gussets stand and the front panel lies smooth. Stop before the seams strain or the top edge bows outward: an overfilled bag looks as wrong as a collapsed one.

Close it the way it is carried. Fasten the flap, run the zip to its end, press the magnetic snap shut and do up the buckles of a satchel. A structured bag with a rigid frame needs little more than a wipe; soft leather, canvas and nylon need the most filling. Take the wrapping off the handles and wipe finger marks from the metal plates.

2. Top handle up, strap accounted for

Take the front photo straight on, with the lens at the height of the middle of the front panel. From higher up the bag narrows toward its base; from lower down the top handle looms over the body. Step back until there is clear space above the handle and beneath the feet.

Handles and straps are the parts that wander. A top handle belongs upright above the opening and not folded across the logo; a loop of clear thread tied to a shelf above, or a roll of paper inside the handle, holds it there. A long shoulder strap either rises to a hook so its drop can be seen, or lies in one loose curve beside the bag, never out of the picture and back in again. A detachable strap can be attached in one photo and laid out straight in the next, which also shows its length and its clips. Measure the strap drop, from the top edge of the bag to the highest point of the strap, and write it in the listing.

3. Gusset, back panel and base

Turn the bag a quarter and photograph the gusset. Its width tells a buyer how much the bag holds, and its folds show how the bag has been stored. The back panel gets a photo of its own, above all where it carries a slip pocket or a zip. Then lay the bag on its back and photograph the base, with its metal feet or its bare corners.

Leave the phone where it is for these views and move only the bag. A set that shares one background, one light and one scale reads as a single object seen from every side.

4. Hardware, zips and stitching up close

Metal is where a bag catches the room. Clasps, rings, buckles, studs and zip pulls return the window as a white flare and the phone as a dark rectangle. Turn the bag by a few degrees, or lift the phone slightly, until the flare slides off the engraved area. A sheet of white paper held just outside the picture fills the dark side of a buckle with an even tone.

Move in for separate close-ups: the main clasp, the zip pull with the teeth of the zip in view, a strap ring where leather meets metal, and a run of stitching along a handle. Keep the phone far enough away to focus, and tap the screen on the metal. These photos show plating that has worn through to another colour, scratches on a turn lock and the regularity of the stitches.

5. Lining, inner pockets and the tag inside

The interior is a dark hollow, and the phone sets its exposure for the bright outside. Take the stuffing out, hold the opening wide toward the window and tap on the lining so the exposure follows it. White paper laid in the bottom throws light back up the sides. Photograph the lining as a whole, then each inner pocket, the zipped compartment and the underside of the flap.

Somewhere inside sits the evidence of what the bag is: a stamped leather tab, a sewn label, or a serial or date code on a small tag in a pocket seam. Photograph each one flat and sharp enough to read at full zoom, and keep the file as the phone saved it, since a forwarded copy is too small for a stamp to stay legible.

6. Corners, edges and handle wear

A used bag wears in predictable places: the corners of the base, the piping along the edges, the handles where hands darken the leather, the painted edges of the strap and the lining at the bottom of the main compartment. Photograph each of them, clean ones included, because a sharp photo of an unworn corner is evidence too.

Side light shows scratches and creases, so turn the bag until the mark is visible on the screen before pressing the shutter, and leave colour and contrast as recorded. A stain inside, a pen mark, a loose thread, tarnish on a ring or a replaced zip pull belongs in both the photos and the description. Finish with one photo of everything included in the sale: dust bag, strap, lock and keys, box.

Where bag photos usually go wrong

A top handle that falls forward is the commonest fault: it lays a dark curve across the front panel, often right over the logo plate, and the bag reads as two halves. Lift it upright or let it drop behind. A detachable strap left in a heap beside the base looks like a second accessory, so clip it on or lay it out. A ceiling lamp leaves a hard shadow under the handle and inside the opening, and the edge of the flap disappears into it.

Colour drift is quieter. A tan bag next to a green wall or on a red rug takes on that tint, and buyers judge the shade from the photo. A neutral ground keeps the leather honest. A front view taken with the bag turned slightly shows one gusset only, and the bag looks lopsided. In Virtual try-on, a photo that shows only the back panel, or a bag still sealed in its shop packaging, is flagged before anything is generated.

When a bag needs a photographer, not a phone

Some evidence has to come from the real bag at close range. A stamped serial code, a heat-embossed logo or the scale pattern of exotic leather is read at a magnification where a phone struggles with both focus and light, and buyers of a pre-owned designer bag often ask for exactly those frames. Someone working with a macro lens and a lit table records them in one sitting, sharp enough to compare with a reference.

Detail shot does not replace that step: it builds its close-up from the pixels already in the upload, and texture too fine for them is not invented. Scale is the other limit. The try-on is briefed to keep the bag at its real size, judged from its buckles and stitching, but the image is not a measurement, so the strap drop and the width of a tote still need a tape measure and the listing text.

Black, white and patent bags in window light

A black leather bag fills most of the frame with dark tones, and the phone brightens the scene until the leather turns charcoal and grainy. Lower the exposure until the black is deep again, then look at the edges: a white card on the shadow side draws a thin highlight along the seams and the piping, which keeps the silhouette readable. Black on a black ground loses its outline, while mid-grey holds it.

A white or cream bag is the reverse case. The camera darkens it towards grey, and raising the exposure far enough to restore the white can burn out the stitching on the front panel; stop while the stitches are still visible at full zoom. Patent leather and coated canvas act as mirrors, so move the light further back until one broad, soft highlight runs along the curve instead of the sharp shape of a window.

Checklist

  • Bag emptied, stuffed and closed
  • Front straight on, handle upright, whole strap in frame
  • Gusset, back panel and base as separate photos
  • Clasp, zip and stitching close-ups without glare
  • Lining, inner pockets and the inside tag, readable
  • Corners, edges and handles, worn or clean

Updated 12 October 2026

Questions

In short.

What can a bag be stuffed with for photos?

Tissue paper, bubble wrap, a small cushion or a folded towel. Fill the corners of the base first and stop when the sides stand and the front is smooth; none of the filling should show through the opening.

How is a bag with a long strap photographed?

Lift the strap to a hook above the bag so the whole drop is in the picture, or lay it in a single loose curve to one side. Either way the full strap stays inside the frame and does not cross the front panel.

Is it better to hang a bag or stand it up?

Stand it when the base holds, since the silhouette is designed that way. Soft, unstructured bags that will not stand can hang from a hook; expect the hanging bag to look longer and narrower than it does on a table.

How is the inside of a dark bag photographed?

Remove the stuffing, open the bag toward a window and tap the lining on the screen so the phone brightens it. White paper in the bottom reflects light onto the sides.

Do scratches on a used bag have to be shown?

Showing them is the sound choice. Corner wear, darkened handles and worn plating are what a buyer of a used bag looks for first, and a clear photo of each, matched by the description, leaves little to dispute.

What ground suits a tan or cognac leather bag?

A light grey or an off-white. A warm wooden floor or a beige wall pushes the leather further towards orange, and buyers take their sense of the shade from the photo. Compare the screen with the bag in daylight before uploading, and retake the photo rather than correcting the shade by eye.

Will the print on a tote stay where it is in a studio image?

Product studio is briefed to keep a print in its place on the front panel, at the same height below the top edge and the same size relative to the panel, with the handles kept clear of it. Compare its position with the source photo before publishing, above all where a handle crossed the print in that photo.

Related
Get started

Your next collection, shot this week.

20 credits at sign-up, no card required. Images made with free credits carry a watermark. Herofab also removes the watermark from those images once credits are purchased.